Page 1 of 1

tS7.6 - Scene Trigger

Posted: 24 Jan 2010, 02:08
by trueBlue
tS76 Scene Trigger
SceneTrigger.JPG
Loads a scene from your hard drive or CD/DVD when triggered in FPN mode.

The trigger is hooked to a flat circle with the Render Attributes adjusted to show only vertices/points. The circle of points represents the Active Radius which is set at 5. This is just an approximation and if you change the Active Radius and or the Scale then this would not be valid anymore. It's only purpose is to give you a visual aid when placing into your scene. There is also Trigger - Invisible check box to hide it.
Instructions:
Load and place the Scene Trigger into your scene. Use the file dialog button to navigate to your scene that you want loaded once triggered in FPN mode.